X
.jpg)
.jpg)
This wire is for the stepper motors that are most frequently used on 3D printers. The total length of this wire is 700mm, the pitch (distance between pin to pin) is 2.54mm.
This wire is not available for the shaft-reversed stepper motors.
TOP
Will this be suitable to replace an extruder motor on A20M?
Dear customer, it is suitable for A20M, thanks for your conconsulttion , if you have any problems you can contact me mailbox: myorder@geeetech.com .hope you have a good day .
Ho dovuto sostituire la Vs scheda GT2560 V4.0 causa bruciatura. Montato il tutto, invertito i cavi per il motore X, Y, Z OK tutto bene, il motore invece dell'estrusore 0 non funziona e il motore dell'estrusore 1 va bene ma gira al contrario. Mi potete far avere il disegno delle connessioni dei contatti. La mia stampante e una GEEETECH A20M. Grazie
Dear customer, you can contact our technical supports mailbox : support@geeetech.com or create a ticket on our official website ,hope you have a good day .
Could you provide me the SKU for the POWER CABLE (the one that connects the PSU (power supply unit) to the board) for the Acrylic Prusa i3 Pro B printer?
Hello, I will feedback your questions to technical support. I will send it to your mailbox later. Please check it. Thank you for your consultation. this is my mailbox myorder@geeetech.com ,if you have porblem please let me know .
I need cables for my A10 these are E0_m,FDO and also X_ES,X_M
Please place an order with this SKU: 45-005-0448, but write a comment for your order ,need sku: 37-001-0362 and sku: 37-001-0368.
i need A20M X axis cable
hello, pls order this SKU: 800-001-0477 item, but write a comment for your order, machine model and product desired. we will send it to you .
Passt es beim A20t
Hello, Kai it is not suitable for A20T,please confirm your motherboard verson? And the wire for which axis, so that we can check for you.
Danke für die schnelle Info hier die Daten_br_GT2560 V4.1 /Baud 250000 Fw V 2.2 HW V2.20 Protocol1_br__br_Es ist der 1. Extruder Kabel oben (E0)_br__br_hoffe es hilft_br__br_MfG_br_Diehl
Kai, is it for X axis, Y axis, or Z axis?
Es ist nicht für Achsen sondern für den Extruder 1(E0)
hello, seems you need extruder cable . it is not listed on our store ,pls contact sales@geeetech.com, she will arrange it for you .
What is the exact model and type of the 6 pin connector please. It looks to be JST XH 2.54mm 6 pin male, but the spacing is a lot smaller. Can't find it anywhere...
hello, pls send a photo of the parts you are looking for to sales@geeetech.com, will check for you, thanks
Hi, is this wire stock in EU warehouse or will you ship it from china?
Hi Oli,this will be shipped from China ,as our EU warehouse just have stock by printers.