This V4.0 bord can only be a replacement for V4.0 board .
GT2560 V4.0 control board, developed by Geeetech, is currently used for A10, A10M, A20 and A20M 3D printers. Here are its main features:
1. Using ATMEGA2560 as its core chip, with its flash memory at 256KB and operating frequency at 16MHz.
2. Compatible with 12V/24V input voltage. Featuring dual power supply, one for powering up the heatbed (15A), the other for other electronic parts (10A).
3. The interface for the heatbed comes with a high-power MOS tube, which is of ultra-low conductive internal resistance. High performance and stable.
4. With 2 interfaces for normally open fans and 1 interface for LED light.
5. Driven by 6 A4988 stepper motors for a single extruder or multiples ones.
6. With extension interfaces for LCD display and SD card. Support both 2004 and 12864 LCD display.
7. Support 3D touch auto-leveling function and filament detector.
8. Using Marlin firmware, stable and easy to operate.
9. Highly integrated and easy to assemble.
Specifications:
Net weight: 72g
Gross weight: 113g
I have an a10m with a board that is a v4.1b no one has a clue about it and it don't work so I need a replacement will this one work
hello, pls order this one , but leave a comment for your order , need A10M v4.1b board instead . i will change order for you when i process orders.
i am changing from a 3.0 board and need new cables can you add them to my order please, this is a lot more expensive than i thought it was going to be
hello, yes, these cables are not listed on our store , you can send email to sales@geeetech.com , i will arrange for you
Hello what is the part number for the cable needed for this board?
hello, if you change from 3.0/ 3.1 board into 4.0 board , need change all the cables connect to control board. sorry, these cables are not listed on our store , you can send an email to sales@geeetech.com ,pls let me know which board does your printer currently have , we will arrange for you offline.
Hi, My GT2560 V3.0 of my Geeetech A10M was broken, i can't find a new one with V3, wich one could fit in my machine, the version 3.1 or the version 4.0? and what else need to fit on int? Regards
hello , sorry we do not produce 3.0 board anymore. you can change into 3.1 board, also need a new LCD 700-001-1196. if change into 4.0 board, need new lcd , also all the cables on control board. any more inquiry, you can email to sales@geeetech.com
Save: 20% off
Save: 20% off
Save: 22% off
TERMS OF USE
HELP CENTER
COMPANY INFORMATION
MEMBER AREA