if you need it for specific model printer , pls write a comment for your order ,
need A30T hotend thermistor instead ( if your printer is A30T).
This 100K NTC thermsitor MF58 is recommended as temperature sensor to use with Geeetech(JIETAI) hotend.
Resistance value | R(25°C)=100K±1% |
B Value: | B=3950±3% |
Insulation resistance | 50MΩ or over by DC500V megger (between glass and lead wire) |
Thermal time constant (τ) | τ≤Sec(in still air) |
Thermal dissipation constant (δ) | δ=2.1mW/°C (in still air) |
Operating temperature range | -40°C~+300°C |
Hi, is this for A10 hotend?
no , you can order it , but write a comment for your order , need A10 hotend thermistor instead . usd 2.9= 1pcs
Hey, is this for 12v or 24v output?
this is not related with voltage but resistance, thanks
Is this the correct thermister for the Geeetech Aluminum Prusa I3 3D Printer kit?
HI Daryl ,yes it can usd on Aluminum printer.
I am getting a Err: MINTEMP for the HotEnd. After switching with the sensor from the bed the termperature is OK. I have a prusa i3 pro B with MK8 extruder. Is this thermistor is the one used in my extruder?
Yes Aurelien, this is the thermistor for the MK8 extruder.
Is this thermistor for the M201 Printer ?
Hello Lawrence, Yes,it is the thermistor for the M201 Printer.
John zhao, not is WHERE this we know, is WHAT IS, we need the thermistor table.
What is the thermistor table in Marlin for this component?
In the file configuration.h
Do you have a data sheet for this component?