X
.jpg)
.jpg)
The NTC Thermistor is widely used to protect the electronic equipment from high purity and uniform materials to achieve a construction of near-perfect theoretical density. This ensures small size, tight resistance and B value torelance, and fast response against temperature variation, making a highly sensitive and precision component. NTC Thermistor is available in wide range to meet your demands for small size and high reliability.
Resistance value | R（25°C）=100K±1% |
B Value: | B=3950±1% |
Insulation resistance | 50MΩ or over by DC500V megger (between glass and lead wire) |
Thermal time constant (τ) | τ≤10～17s (in still air) |
Thermal dissipation constant (δ) | δ=1.1～1.6mW/°C (in still air) |
Operating temperature range | -50～+260°C |
Packing list:
10 x 100K ohm NTC Thermistors for heated bed
TOP
Please replace with the Thermistors for the hotend_br_
Ok, it has been recorded for you. Thank you for your support to Geeetech.
Hello, can I use it on my Prusa I3 Pro W?
Yes,sure.
Hello, can I use it on my A10M hotbed (GT2560 - V 3.0)?
Yes, Joao, it can be used fro A10M hotbed
Hello, can I use this thermistor for Geeetech A10 ? Is there anything else to do appart from wiring it and fixing it to the nozzle ?
hello, it is for heatbed, not for hotend. if you need for A10 hotend, pls send email to sales@geeetech.com
Is this Thermistor the Same as the hotend thermistor for Geeetech A30?
hello, it is not the same, but can use it
Can i use these on the A20M
yes
please use the heat retardant taps, thanks
how to fix or glue it to the hotbed?
Are these OK to use on a GEEETech A30 as a temperature sensor, fixed to the side of a heater block?
yes, it can use