Relatives
Recently Viewed
Small fan, for mounting on an extruder for example.
Dimensions: 40x40x10mm
Voltage: 12V
current:0.11A
Power connector:2pin
cable: 150mm
Come here for a smaller one of 30x3omm.
Small fan, for mounting on an extruder for example.
Dimensions: 40x40x10mm
Voltage: 12V
current:0.11A
Power connector:2pin
cable: 150mm
Come here for a smaller one of 30x3omm.
In an earlier post I was asking to purchase a fan unfortunately I put the main board wrong my printer is fitted with a GT2560 main board. The fan you have listed has a different plug the one I have is a white 3 pin plug so I hope you can help.
can you please send mails to jocelin.jia@geeetech.cn, thanks
Will the 0.17 amp fan work with 0.9 amps?
I have a Geeetech i3 Pro B Printer fitted with a GT2580 main board with two 40x40x10 fans labelled Geeetech Model 12v DC fan along with your internet address.
This fan can use on PROB, thanks
I sent you a reply 3 or 4 days ago with reference to the fan pictured. I know I can use the fan but the plug is different. The fans used on my printer are 2 wired three pinned plugs can you tell me if you have these in stock so I can order some.
I am after two 40x40x10 12v fan which I believe is 2 wire 3 pin with a white male plug which I think is called a molex plug. I am also after two extension cables to fit the fans which should be female to male I hope somebody can help or point me in the right direction to where I can purchase them from.
Hello Mark, can u tell me which modles you use?
use on extruder, right? now the fans we use is this kind of fan
I really hope this is the 40mm fan. The image says 30mm which does NOT inspire confidence... We shall see when the order gets here.
Where can i find Cabel adapter from 2pin(fan) to 3 pin(motherboard) ??
Seems this is not a pwm fan that can be used with gt2560. Could you please suggest the right one?
Hi Danilo,this one is suitable for the GT2560.
thanks,my order is very good
Hello Yves,sounds great.
what is the yellow wire for and could I use a fan with only two wires blk and red.?
the yellow wire is for s pin, if you have only two pin connector, you can use the blk and red wire
where can I get an extender cable, I've looked for 3 pin Dupont cables and haven't had any luck. What do I need to search for, for the connector on this fan?
http://www.geeetech.com/fan-extention-wire-mm-1200mm-p-1000.html here it is
thanks, just ordered some!
Will this work with the mk8 dual extruder?
yes, it is the one used on MK8 Extruder.
TERMS OF USE
HELP CENTER
COMPANY INFORMATION
MEMBER AREA