X
About this item
ăPETG FILAMENTă PETG filament offers stiff, durable strength (like ABS) and ease of use (like PLA)â
no heating bed needed, equipped with good gloss, corrosion resistance.
ăTOLERANCE ± 0.03mm ă PETG 1.75mm 3D printer filament are produced with more precise specification,
and have a tolerance of only +/- 0.03 mm. Compatible with MOST FDM 3D printers.
ăVACUUM PACKAGINGă Vacuum sealed with desiccant to maintain low level of moisture content.
And please keep it dry and dust-free after after opening the sealed package to prevent it becomes brittle or jams the nozzle.
ăEASY-TO-USE, CLOG-FREE, BUBBLE -FREEă
Designed and Manufactured to guarantee a smooth and stable printing experience.
Recommended extruding temperature 220-240°C (428°F -464°F), heatbed temperature 80-90°C(176 194â).
Works perfectly with all common 1.75mm FDM 3D printers.
Specs:
Net weight: 1 kg
Color: PETG Transparent
Filament size: 1.75mm
TOP
This is a good transparent filament and quite easy to use. Works well at the normal temperatures for PTEG and I found it had excellent adhesion to a PEI bed, even when cold. Layer adhesion is good, print speeds are very good and the surface finish is what you'd expect from a high-quality PETG. It did arrive a little damp which I suspect contributed to it having more-than-normal stringing and the transparency not being the best but both were greatly improved by 12hrs@60C drying cycle. After drying the stringing was minimal and the transparency was normal for PETG
Hi Stephen, Thank you for your good review and liking of PETG transparent,have a nice day.
Just purchased a roll of PETG Transparent thru Amazon to try out. Your website recommends extruding temperature 220-240°C (428°F -464°F), heatbed temperature 80-90°C(176 194â). Any additional setting would you recommend? What would you recommend for drying? Will your spools take the drying temperature? I have a Bambu X1c with an AMS and a Crealty Pi for drying.
Hi JeffïŒ Hope you are doing well. The recommended dryer temperature for the PETG filament is between 60-70 â, and the drying time is 6-8 hours. We suggest that you set generic filament models on Bambu Studio,and first layer of the printing nozzle is 235â, and other layers 230â. The hotbed can be set to 85â. Have a nice day.
Please check the filament length of the petg plastic. there can't be 130 meters per kilogram._br_PLA - 1.24 gr - 1.75mm - 335m_br_2.85mm - 126m_br_PETG - 1.27 gr. - 1.75mm - 327m_br_2.85mm - 123m
hello ,PETG filament leength is standard ,if you have any problem you can contact me through the email box myorder@geeetech.com.
Excelent filament. I printed the transparent PETG at 250 degrees C, 0.6 nozzle on Prusament PETG settings (except temperature), and almost no stringing. Its better than PLA in this regard
Thank you for your support to geeetech, welcome to buy again.