Mac - 10.14.3 and printer i3 ProW 3D with 340C chip

Post Reply
get me to work
Posts: 4
Joined: Sun Mar 03, 2019 7:13 pm

Mac - 10.14.3 and printer i3 ProW 3D with 340C chip

Post by get me to work » Sun Mar 03, 2019 7:40 pm

I need help.
Running - Mac Mojave 10.14.3
Printer - i3 ProW 3D 340c Chip

I have...
Downloaded installed FTDIUSBSerialDriverv2.4.2
Repetier - Host Mac1.2.0

The I opened and Repetier and - printer settings - connection - (two appear when usb connected) usbserial-1420 and wchusbserial1420.
but at the bottom it shows commands waiting and 1249FPS Unknown printer firmware... (but the number can change with every click -630,1291.1116,967.1338,1184)

Downloaded and installed Arduino 1.0.1 and 1.8.7 opened and ran.

If someone can advise how i connect Mac to printer... then which correct software and in order of loading and what I should expect to see on the green LCD... I then still have to calibrate and print something.

If anyone can help I would be grateful

get me to work
Posts: 4
Joined: Sun Mar 03, 2019 7:13 pm

Re: Mac - 10.14.3 and printer i3 ProW 3D with 340C chip

Post by get me to work » Sun Mar 03, 2019 11:41 pm

This has now ben sorted......

Some how I have sorted the issue..... it may have been the corresponding Arduino 1.0.1 and Marlin.....
Now using Repetier host to operate printer.

evanagomes
Posts: 1
Joined: Mon Mar 04, 2019 1:01 pm

Re: Mac - 10.14.3 and printer i3 ProW 3D with 340C chip

Post by evanagomes » Mon Mar 04, 2019 1:38 pm

is this suitable for iPhone? I am facing lots of issue after updating the firmware on my device. I want to avoid iTunes error 9. If you have any idea about it please inform us.

Post Reply