Require full Prusa I3 Aluminium Kit Assembly Instructions

[zhangxueyou]

You are welcome. Hope you enjoy your printing later.

Cheung Weng

[Anabatix]

Hi,
A couple more questions.

1. I think I must cut the white plug off the 12vDC power, strip and screw into board directly? As the photo you show can't be the same board design as in the kit for Ramps 1.4... correct?
2. The 2x Z Axis stepper motors, the white plugs to connect to the Ramps board will never fit. Have you tried it on your Kit. What do you suggest for an easy fix?
3. Could you post some good photos of a completed Prusa Alu Kitset so I can check the layout is as intended. Your manual does not show board or extruder mounting etc. And cable layout around motors.
4. Could you post a Ramps 1.4 finished wiring photo as it is worth 1000 words. And will explain better the power, fan and heatbed wiring using this kitset.

Thanks,

Lee

[zhangxueyou]

I will give you the pictures of all the wiring of all the parts. Please, you must understand my pictures because I spent a lot time assembling. If you have any problem, please reply me T_T
Ramp1.4+Mega2560

image1.png (319.87 KiB) Viewed 31219 times

image2.png (450.45 KiB) Viewed 31219 times

Jumper caps

image3.png (596.52 KiB) Viewed 31219 times

[zhangxueyou]

Cooling fan for mainboard

Cooling fan.png (397.42 KiB) Viewed 31220 times

Cooling fan2.png (524.28 KiB) Viewed 31220 times

Extruder motor

Extruder motor wiring.png (601.39 KiB) Viewed 31220 times

[zhangxueyou]

Themistor on hotbed

Thermistor on hotbed2.png (183.19 KiB) Viewed 31220 times

Thermistor on hotbed.png (806.05 KiB) Viewed 31220 times

[zhangxueyou]

Hotbed

hotbed.png (373.92 KiB) Viewed 31220 times

hotbed wiring.png (345.6 KiB) Viewed 31220 times

Wirng of Endstop

wiring of endstop.png (557.72 KiB) Viewed 31220 times

[zhangxueyou]

Power supply

[zhangxueyou]

LCD

LCD.png (493.32 KiB) Viewed 31220 times

LCD wiring.png (569.16 KiB) Viewed 31220 times

[zhangxueyou]

Wiring of extruder

Wiring of extruder.png (534.37 KiB) Viewed 31220 times

Wiring of thermistor for extruder

Wiring of themistor for Exturder.png (419.83 KiB) Viewed 31220 times

[zhangxueyou]

Switch

switch1.png (345.89 KiB) Viewed 31220 times

switch2.png (561.54 KiB) Viewed 31220 times