Hello,
I just receive my A30M.
Does anyone have a photo on how to install the 3D touch et how to connect it.
I only found information about A20M but nothing for A30M and its really différent.
Regards,
A30M and 3D Touch
Re: A30M and 3D Touch
Hi, you can refer to this:
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: A30M and 3D Touch
Thanks William,
But I really need a photo for a A30M.
It looks like the wires of the 3DTouch are too short to be connected
There is certainly something I doing wrong but I dont find it
But I really need a photo for a A30M.
It looks like the wires of the 3DTouch are too short to be connected
There is certainly something I doing wrong but I dont find it
Re: A30M and 3D Touch
Hi, The connection method of this adapter board is like this:
and you can provide your picture.
and you can provide your picture.
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: A30M and 3D Touch
There were no instructions supplied with the 3D Touch when it arrived with my new A30M.
Is it possible you can provide an image of the 3D Touch installed on the head? I have just installed the 3D Touch on my A30M and the wires seem very tight.
I'm not sure how high to adjust the sensor either. What height should the 3D Touch pin be in relation to the nozzle?
Is it possible you can provide an image of the 3D Touch installed on the head? I have just installed the 3D Touch on my A30M and the wires seem very tight.
I'm not sure how high to adjust the sensor either. What height should the 3D Touch pin be in relation to the nozzle?
Re: A30M and 3D Touch
!
Last edited by Maccron on Sun Feb 07, 2021 4:43 am, edited 1 time in total.
A30M with 3DTouch.
Re: A30M and 3D Touch
My wires are too short as well to connect to the board. Did you have to make your own extension cords?
Thanks, Marius
Thanks, Marius
Re: A30M and 3D Touch
never mind. Had the bracket upside down and managed to get the cable to fit
Re: A30M and 3D Touch
I have near given up on trying to get the 3D Touch to work on my A30M. I have had to bend the 3-D touch pin back into shape twice after it collided with the side of the bed. I haven’t been able to find a YouTube that shows the latest A30M auto-level software update and how to configure autoleveling. The manual doesn’t provide step by step guidance on how to set it up. We are all relying on forums to try to help each other out which seems crazy. I bought this printer because of this functionality which is sadly letting many of us down. I’m scared to try anything as it keeps trying to drive the hot end through the build plate.