When using autohome the z-axel just goes up a bit but not home.
The happened suddenly.
What can I do?
homing z-axel
Re: homing z-axel
Hi
I would try to press the appropriate stepstick into the socket.
Of course, the power supply to the printer must be switched off first.
I would try to press the appropriate stepstick into the socket.
Of course, the power supply to the printer must be switched off first.
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Re: homing z-axel
It ok one moment and the next the z-axel only moves up (in homing).
When I manualy want to move the z-axel with the turn button, it can move up and down. So I think the wirering is ok.
When I manualy want to move the z-axel with the turn button, it can move up and down. So I think the wirering is ok.
Re: homing z-axel
I stupid!!!
Ginko, you were right! I overlooked that one wire of the endstop came loose!
Thank you so much for helping!
Ginko, you were right! I overlooked that one wire of the endstop came loose!
Thank you so much for helping!