Ardurimu

Post Reply
masterPro
Posts: 2
Joined: Sat Mar 02, 2013 11:42 am

Ardurimu

Post by masterPro » Sat Mar 02, 2013 12:10 pm

When following these instructions

https://dev.qu.tu-berlin.de/projects/sf ... i/Tutorial


When Calibrating the gyro sensor returns nothing

Image

I have tried using a 3.3 v FTDI breakout board and i changed the jumper in the back to see if it will respond. IT does not.

I also notice that this board is using the ITG3205 and the tutorial is using ITG3200.

But i cant find differences in Address. I have also tried a I2C Address scanner found on arduino

http://playground.arduino.cc/Main/I2cScanner

with no luck. :(

User avatar
techsupport
Site Admin
Posts: 210
Joined: Sat Mar 03, 2012 2:32 pm

Re: Ardurimu

Post by techsupport » Tue Mar 05, 2013 10:14 am

Hi friend

Please try to use 5V FTDI breakout and test the sensors individually according to the wiki page http://www.geeetech.com/wiki/index.php/Product. ITG3205 is no

different to ITG3200.

Regards,
techsupport
Your real trustworthy partner in China!!
Email: forum@geeetech.com

masterPro
Posts: 2
Joined: Sat Mar 02, 2013 11:42 am

Re: Ardurimu

Post by masterPro » Tue Mar 05, 2013 10:31 am

I am using a 3.3v breakout and i jumped the back breaker to 5 and i tested it.


I get the same result after i changed the jumper

User avatar
techsupport
Site Admin
Posts: 210
Joined: Sat Mar 03, 2012 2:32 pm

Re: Ardurimu

Post by techsupport » Thu Mar 07, 2013 10:03 am

What about the sensor ADXL345, ITG3205, HMC5883L when you test them individually according to the wiki page?
Your real trustworthy partner in China!!
Email: forum@geeetech.com

Post Reply