Hi,
could it be, that the firmware V1.37.58 has an issue to hold the selected nozzle temperature?
If I print a model with maybe 210 degrees nozzle temperature, than it change always between 208 and 212 degrees.
Imthought with the older firmware version was this always stable or only 1 degrees difference.
What are yours experience?
P_rhodan
Issue with nozzle temp in firmware V1.37.58?
Re: Issue with nozzle temp in firmware V1.37.58?
I'm having the same issue.. Not sure what to do.
I'd suggest running a PID Autotune but Smartto doesn't support it.
P.S. Smartto firmware sucks.
I'd suggest running a PID Autotune but Smartto doesn't support it.
P.S. Smartto firmware sucks.
Re: Issue with nozzle temp in firmware V1.37.58?
Such a nice kitten and she speaks so badly. Shame on you.
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Re: Issue with nozzle temp in firmware V1.37.58?
Any other information? Would this be fixed in the next firmware update?
Re: Issue with nozzle temp in firmware V1.37.58?
Hello.
As far as I know, the work on improving the firmware is very intensive.
As far as I know, the work on improving the firmware is very intensive.
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Re: Issue with nozzle temp in firmware V1.37.58?
Very good!
Any release date available? When can we get the new firmware?
Thanx!
Any release date available? When can we get the new firmware?
Thanx!
Re: Issue with nozzle temp in firmware V1.37.58?
you will find it on the geeetech.com page under download
the new upgrader is in the software section
the new upgrader is in the software section