Hi There,
I'm trying to print a key holder example made by me but the second extruder is printing out of the correct location.
Please see the attached photo.
When I use Slic3r the extruder print at same time and side by side. This gcode was generated with CURA and the result is above.
Any suggestion?
Best,
RMRodrigues.
Multi Color Printing Problem
Re: Multi Color Printing Problem
the photo is broken...
-
- Posts: 42
- Joined: Wed Oct 14, 2015 5:37 am
Re: Multi Color Printing Problem
Here is it:
Thanks Mark.
Thanks Mark.
Re: Multi Color Printing Problem
oh I see you use cura, sorry I haven't used it before...
-
- Posts: 42
- Joined: Wed Oct 14, 2015 5:37 am
Re: Multi Color Printing Problem
Hi Mark,
I've used CURA as an alternative to Slic3r.
There is a guide to do that on Slic3r?
Thanks.
I've used CURA as an alternative to Slic3r.
There is a guide to do that on Slic3r?
Thanks.
-
- Posts: 42
- Joined: Wed Oct 14, 2015 5:37 am
Re: Multi Color Printing Problem
Mark I think that my problem is due to a bad offset. What you think about that?
Re: Multi Color Printing Problem
I think you can refer to this link to check the settings:
http://www.geeetech.com/wiki/index.php/ ... _extruders
http://www.geeetech.com/wiki/index.php/ ... _extruders