Skew prints on print bed

[Aeonster]

Hi,

I have a Rostock Mini G2s, when I print I've noticed my prints are somewhat skewed.

I've made a small illustration to show the situation:

Skewed Illustration

skev3Dprint.gif (7.64 KiB) Viewed 6543 times

The lightblue is the print on the printed bed.
The gray is printbed, darkblue are the towers X/Y/Z
and the Red line is a straight line to see the difference.

I've tried some leveling of the printbed, and head and even auto-leveling, but no results.
So my question is if there is any other thing I can try or do to try and solve this?

Thanks.

[Sherry]

hi,maybe the parameter of the filmware is not correct.please do the following steps
1.Open the configuration.h file in the firmware.Find the following stsements.
// Horizontal distance bridged by diagonal push rods when effector is centered.
#define DELTA_RADIUS (DELTA_SMOOTH_ROD_OFFSET-DELTA_EFFECTOR_OFFSET-DELTA_CARRIAGE_OFFSET+2)
2.Modify the parameter "+2".there are some errors when assembling the printer.Please try to find the appropriate parameter when doing auto-leveling.It maybe a minus.

[antibore]

Did the proposed solution work for you? I have the exact same problem..

[Mark]

Have you guys set the right settings in repetier and slic3r?
refer to the extruder offset here:
http://www.geeetech.com/forum/viewtopic ... 13&t=17064