Rostock Mini G2S Pro board fan position changed?

Post Reply
sonicthehedgehog
Posts: 1
Joined: Wed Mar 08, 2017 12:45 am

Rostock Mini G2S Pro board fan position changed?

Post by sonicthehedgehog » Sat Mar 11, 2017 2:50 am

Hi,
I've raised a ticket just in case, but I was wondering if anyone had any experience or suggestions.
When assembling the mainboard section, the positioning of the board fan doesn't match that in the build doc and videos I've seen - in those the board fan's off to the side of the mainboard, instead of parallel between the board and the LCD.

From that position, the fan lead's not long enough to plug into the socket, and I'm not sure about rotating the board 180degrees in case of difficulty plugging the USB connection in.
Have I missed anything obvious there?

Many thanks.
IMG_20170310_183104388 - Copy.jpg
IMG_20170310_183104388 - Copy.jpg (993.82 KiB) Viewed 7030 times

bang
Posts: 402
Joined: Wed Dec 28, 2016 2:12 pm

Re: Rostock Mini G2S Pro board fan position changed?

Post by bang » Tue Mar 14, 2017 11:39 am

I guess the holes for your fan were incorrectly drilled...

mclightning
Posts: 1
Joined: Sun Aug 06, 2017 7:01 am

Re: Rostock Mini G2S Pro board fan position changed?

Post by mclightning » Sun Aug 06, 2017 5:08 pm

Mine also same problem. Any solution for this? Is it dangerous to use the 3d printer in this arrangement?

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Rostock Mini G2S Pro board fan position changed?

Post by William » Mon Aug 07, 2017 10:45 am

It is obvious that the direction of installing fan is wrong that result to the difficult in plugging into the socket and heat dissipation .
the right position where there are several holes for installing fan has been marked in the picture.
Attachments
20170807104324.jpg
20170807104324.jpg (26.45 KiB) Viewed 6798 times
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply