GT2560 testing and no luck
GT2560 testing and no luck
Hi,could you tell me which version is your nema 17 stepper motors ?I think the driver board didn't have enough voltage to driver the motor,maybe you can increase it or replace with A4988 to have a try.
Re: GT2560 testing and no luck
Hi,
What exactly are you having problems with? One motor? All the motors? Which axis? X? Y? Z? or the extruder?
Check the stepper motor forums and you'll find information about how to increase the current through the motors and therefore the power to each by adjusting the Vref on the driver board. the voltage should be about 0.8V for 1 Amp of drive current through the coils.
Play Bonny!
Soadyheid.
What exactly are you having problems with? One motor? All the motors? Which axis? X? Y? Z? or the extruder?
Check the stepper motor forums and you'll find information about how to increase the current through the motors and therefore the power to each by adjusting the Vref on the driver board. the voltage should be about 0.8V for 1 Amp of drive current through the coils.
Play Bonny!
Soadyheid.
Re: GT2560 testing and no luck
My post has disapeared and has been replaced by another 1, I did not post the " Which version of nema 17 motors " ?? which has been kindly answered by Soadyheid. Sorry about this I will try and find my original post .