Hello
I bought a Prusa i3 m201 about a week ago and have now built it together.
But I can not make it work, only the Y motor moves when i press auto home. X and Z will only sound from.
if I move the cable from Y to X it works. the same applies to the end stops. is there something wrong with the control board?
prusa i3 m201 engine and end stop problems
Re: prusa i3 m201 engine and end stop problems
Hi,please check this post to make troubleshooting:http://www.geeetech.com/forum/viewtopic ... 17&t=17038.
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!