z-axis only 1 on 2 step motro working
z-axis only 1 on 2 step motro working
i just finnish assembling my geeetech i3 and every thing work fine exept one of the 2 step motor controling the z-axis is not working at all
-
- Posts: 1405
- Joined: Fri Feb 06, 2015 1:33 pm
Re: z-axis only 1 on 2 step motro working
Did you connect another z motor to mainboard?
Re: z-axis only 1 on 2 step motro working
i follow the manual you give me and connect it like this
http://www.geeetech.com/wiki/index.php/ ... _pic86.png
http://www.geeetech.com/wiki/index.php/ ... _pic86.png
-
- Posts: 1405
- Joined: Fri Feb 06, 2015 1:33 pm
Re: z-axis only 1 on 2 step motro working
As you can see in the picture, there is still another connector for z motor(above the 3rd A4988) , but you need the extend the z motor wire with a 4 pins Dupont.
Re: z-axis only 1 on 2 step motro working
i think i know my mistake i plug the second z-axis motor on the e-axis but now i think the e-axis is for the motor of the extruder and if im right i just have to switch it