Search found 6 matches
- Sun May 12, 2019 8:25 pm
- Forum: Geeetech I3 Pro B
- Topic: Bad part or am I missing something??
- Replies: 5
- Views: 5275
Re: Bad part or am I missing something??
More bad parts.... I'm going for a refund. Terrible.
- Sun May 12, 2019 8:23 pm
- Forum: Geeetech I3 Pro B
- Topic: Need advice: Geeetech Prusa i3 Pro B or Creality Ender 3?
- Replies: 5
- Views: 9944
Re: Need advice: Geeetech Prusa i3 Pro B or Creality Ender 3?
I'd go with a decent company Greetech parts are awful as you'll see in this forum - plus they delete critical proof of their poor manufacturing too.
- Sun May 12, 2019 12:12 am
- Forum: Feedback&Suggestion
- Topic: To new buyers ... I3 Pro B
- Replies: 1
- Views: 9130
To new buyers ... I3 Pro B
Do not buy this printer. I am going to have to return it for so many basic manufacturing faults. Linear bearing incorrectly drilled. 20190510_004203.jpg Extruder mount washer mis-stamped: 20190511150944__MG_9934.JPG X-Axis mount bent so the bars are not parallel: 20190511160436__MG_9935.JPG One erro...
- Fri May 10, 2019 11:07 pm
- Forum: Geeetech I3 Pro B
- Topic: Bad part or am I missing something??
- Replies: 5
- Views: 5275
Re: Bad part or am I missing something??
I purchased from Amazon via GT-OFFICIAL UK. How do I contact GT-OFFICIAL UK?
- Fri May 10, 2019 3:05 pm
- Forum: Geeetech I3 Pro B
- Topic: Bad part or am I missing something??
- Replies: 5
- Views: 5275
Re: Bad part or am I missing something??
Thank you William, do I do that via the general contact page or is there a special email address?
- Fri May 10, 2019 7:53 am
- Forum: Geeetech I3 Pro B
- Topic: Bad part or am I missing something??
- Replies: 5
- Views: 5275
Bad part or am I missing something??
I am part way through assembly when I need to install the two t-shaped linear bearings. One of the has the holes on the bottom correctly countersunk to allow an M3-6mm screw to fit flush when tightened. The other had the countersunk holes drilled next to the post rather than on the bottom. 20190510_...