Search found 3 matches

by hqueiroga
Fri Feb 08, 2019 6:30 pm
Forum: Products FAQ
Topic: Z AXIS BLOCKED in one direction
Replies: 22
Views: 13682

Re: Z AXIS BLOCKED in one direction

I found out on of the motor modules on the board was damaged. I replaced it with the extruder module and did a test... motor started moving both directions.
by hqueiroga
Fri Feb 08, 2019 6:27 pm
Forum: Geeetech I3 Pro B
Topic: Z Axis: Home is fine, printing too much distance between layers
Replies: 5
Views: 1289

Re: Z Axis: Home is fine, printing too much distance between layers

Hi. Have you found the cause of the problem? I have the same here... homing is ok, Z points are calibrated properly but it starts printing too high (about 5mm higher than the Z home position) and height between layers seems to be too distant so layers don't glue each other.
by hqueiroga
Wed Jan 16, 2019 6:44 am
Forum: Products FAQ
Topic: Z AXIS BLOCKED in one direction
Replies: 22
Views: 13682

Re: Z AXIS BLOCKED in one direction

Hi. Did the new board work? I am facing exactly the same problem. Motors for Z axis only moves down. Everything else working fine...