Geeetech

Hi Robert, Yes the offsets are set in the configuration.h. You would have to look X_MIN_POS/Y_MIN_POS and/or X_MAX_POS/Y_MAX_POS the variables are self descriptive. The MAX POS is usually set to the size of your BED. A few things I would suggest for you to check Are the END Stops connected correctly...

Definitely check what Gingko suggested with the ribbon cable. Are you able to connect via USB ? Are you able to run control the printer using Easyprint ? Make sure you set the correct baud rate 250000 and com port and then click connect. You should be able to control movements using the Easyprint so...

Hi attached is my working Marlin 1.1.8 configuration.h with BL Touch working if you would like to use. Please feel free to use or suggest any improvements. I have the Z axis anti wobble installed. The BL touch works great for the most part but I am struggling with the Z offset when I change or maint...

I had the same problem with easyprint3d. Try setting the baud rate to 250000 Alternately after running the slicer I saved the .gco file on an SD Card and printed it that way. You can also try an different softare like Cura if EasyPrint does not work for you. . I progressed to using Octoprint. I have...

Pretty Cool. I was struggling to get the 3d touch probe working. Just loaded this. I will use this firmware till I get the auto sensing to work. Lots of manual controls on the menu. Thanks.

My starting corners are off. Any idea how I can set this ?

Kiran