0

Your Shopping Cart is empty.

  • XZN CC3D flight control board
    • i i
    • images/l/Geeetech_cc3d_1.jpg images/l/Geeetech_cc3d_1.jpg
    • images/l/Geeetech_cc3d_2.jpg images/l/Geeetech_cc3d_2.jpg
    • images/l/Geeetech_cc3d_3.jpg images/l/Geeetech_cc3d_3.jpg
    • images/l/Geeetech_cc3d_4.jpg images/l/Geeetech_cc3d_4.jpg
XZN CC3D flight control board
INFO

SKU:800-001-0052

Shipping Weight:65g

Free Shipping!

$23.00
Qty:
VS
VOTES

Vote for specials.

0 votes

Easy Print

The CC3D board is an all-in-one stabilization hardware which runs the OpenPilot firmware. It can fly any airframe from fixed wing to an octocopter and is configured and monitored using the OpenPilot Ground Control Station (GCS) software. The CC3D boards have gained great popularity among UAV fans for its small volume, tidy circuit and affordable price.

1. Powerful STM32 32-bit micro controller running at 72MHz, and can reach at 1.25DMips/MHz when performance at 0 wait state memory access.

2. Integrated with MPU6000 (3-axis high-performance gyros and 3-axis high-performance accelerometer), with 16M IC

3. Support GPS and data transmission

4. Operating voltage: 5V

 

 

1. STM32F103, integrated with 16M FLASH

2. MPU6000:3-axis high-performance gyros and 3-axis high-performance accelerometer

3.6-channel signal input

4. 6-channelinput for servo and ESC.

5. External interface for GPS

6. External interface for data transmission

 

Dimension:36mmx36mmx5mm

Weight: 12.6g

 

1 X CC3D flight control board

1 X 8 pin connect wire

2 x 4 pin connect wire

login or register to add your words.

  • Michael kruis | 01/08/2016

    hello, Please help..i purchased the neo 7m and i see it has two plugs wich dont fit, 6 pin + 4 pin 2x wire compass plug can i use the neo7m gps unit on XZN CC3D flight control board on the main port if i switch the 6 pin to 4 pin and not use the 4 pin 2 wire compass?

    • Quentin Qiu | 01/11/2016

      Hello, generally speaking CC3D doesn't support GPS module, but you can try to realize it by doing it yourself.The 4 pin wire for the mian port of CC3D are VCC, RXD, TXD and GND.


  • rita xiang | 08/30/2015

    hello, rangel, if you need us print the user manual for you, please leave a message when you check out, we will ship them together.


  • Antonio Lourenço Rosa Rangel Filho | 08/30/2015

    Dear Mr. if possible would like to print the CC3D flight control board.pdf, however I can not. If you can help my heartfelt thanks anticipate. Best regards Rangel Son