Geeetech Mizar S 3D Printer

From Geeetech Wiki
Revision as of 03:21, 4 May 2023 by Admin (talk | contribs) (How to replace a hotend)

Jump to: navigation, search

Introduction

Product details

Unpacking and proper handling

Slicing

Printer maintenance

How to replace a hotend

Tools necessary for this guide
Wrench size 10 mm

Allen keys – 1.5/2/2.5/3 mm

Flat screwdriver tip width 2.5 mm

Diagonal pliers

Electrical tape

Zip ties

Craft knife or equivalent


Step 1 Preparing

Preheat the nozzle to 220 Celsius from the LCD menu, then unload the filament from the hotend.

Remove the Teflon tube from the hotend.

M1.png

Before moving to step 2, remember to turn the printer off and unplug it from the socket!


Step 2 Disassembling the hotend

Remove the hotend housing and disconnect the hotend thermistor.

Release and remove the two screws that secure the hotend, then unplug all the cables on the extension board.

M3.png

Remove the extension board and the part cooling fan.

M4.png

M5.png

Remove the strain gauge.

M12.png

Step 3 Disconnecting the hotend cables

Remove the bottom cover and disconnect the cooling fan.

M13.png

M14.png

Disconnect the heater cartridge.

M15.png

Cut off the heat-shrink tubing from the connection wire. Avoid cutting the cable.

M7.png

M8.png

Remove the old heater cartridge.

M9.png


Step 4 Install the new hotend kit

Fix the new strain gauge.

M10.png

Install the new hotend.

M11.png

Run the cables of heater cartridge through the textile sleeve.

M16.png

Insert the both heater cables into the connector.

M18.png

Make sure the cables are fully inserted and tightened!

Tighten the textile sleeve with electrical tape.

M19.png

M21.png

Tighten the zip ties and cut the remaining parts.

M23.png

Install the part cooling fan and extension board.

M24.png

Connect all the hotend cables to the extension board.

M25.png

How to clean the hotend and replace a nozzle

Tools necessary for this guide
Tweezers for nozzle

Wrench size 6/10/20 mm

Cleaner rod (1.5mm diameter, 100mm length)

Needle for nozzle

Allen key - 2 mm

How to replace a control board

Tools necessary for this guide
Allen keys – 2.5/3 mm

Flat screwdriver tip width 2.5 mm

How to replace PSU

Tools necessary for this guide
Allen keys - 2.5/3 mm

Philips screwdriver for PSU cables

How to replace a hotbed

Tools necessary for this guide
Allen keys – 3 mm

Flat screwdriver tip width 2.5 mm

Diagonal pilers

Zip ties

How to replace a screen

Tools necessary for this guide
Allen keys - 2.5/3 mm