Difference between revisions of "GLA10"

Revision as of 03:30, 5 February 2024

GLA10 Leveling Files Download Link

GLA10 Leveling Files

Tips

1. Please read this manual carefully for using GLA10 correctly.

2. Please scan the QR code or log in to our website to get the G-code file that GLA10 needs.

3. Please pay attention to safety when leveling the GLA10 hot bed, so as not to hurt your fingers by the moving hot end.

Leveling Preparation

1. Insert the attached CR2032 battery in the battery holder on the GLA10. Please be careful not to install the wrong positive and negative poles when installing the battery.

2. GCode generator for GLA10
Please click the linkhttps://www.geeetech.com/specialpage/GCode_generator_for_GLA10.html

We provide the corresponding G-codes for different hotbed sizes.Please edit the relevant information in the leveling Gcode generator.Then download the GLA10 related G- code file.

3. Please copy or export the leveling Gcode to the Micro SD card.

4. Please clean up the residual filament on the nozzle so as not to affect the leveling accuracy.

The slicing method for leveled test Gcode.

Please install the Cura slicing software (https://ultimaker.com/software/ultimaker-cura/#downloads), then go to the "Marketplace" plug-in market and install the "Auto towers" plug-in, then restart Cura. Go to the Cura main menu "Extensions" and find the sub- Menu "Auto Towers", select "Custom Bed Level Pattern", set the initial layer height and slice to generate a leveling test model

GCode generator for GLA10

1.Please click the link https://www.geeetech.com/specialpage/GCode_generator_for_GLA10.html

2.Please edit the relevant information in the leveling Gcode generator, and then copy or export the leveling Gcode to the Micro SD card.

Start Leveling

1. Power on the 3D printer, select the leveling auxiliary G-code pre-installed in the Micro SD, and start the hotbed leveling.The leveling auxiliary G-code will pause at the four corners of the hot bed for 25s respectively. After 25s, the nozzle will move to the next point. After the pause at the fourth corners, the printer will exit the leveling.

2. After the leveling starts, the nozzle of the printer will automatically lift a certain distance. At this time, please place the end of the GLA10 with a cross pattern under the nozzle, and ensure that the nozzle is directly above the cross pattern of the GLA10.

3. At this time, please press and fix the other end of the GLA10 with one hand, and then quickly adjust the bot bed leveling nut corresponding to the current position of the nozzle with the other hand. When you see the green LED on the GLA10 just lights up, it means the current height of the hot bed is just right. Now, please take out the GLA10 and wait for the hot end moving to the next point. Pay attention that the GLA10 just lights up at all four corners of the hot bed.

4. After leveling, please use the downloaded test G-code to verify the leveling effect.

5. If any problem is found during the leveling test, please re-level the hot bed.

Product Parameters

Battery parameter：CR2032,3V

Product size：90（L）*35（W）*12（H）mm

Packing size：18（L）*75（W）*40（H）mm

Product weight：14.5g

Packing weight：52g