- 3D PRINTER 
- 3D printer filament 
- MICROCONTROLLER 
- Mini PC 
- UAV 
- FRIENDLY ARM 
- ROBOTICS 
- BREAKOUT 
- SENSORS 
- DISPLAY 
- WIRELESS 
- ACCESSORY 
- COMPONENT 
- TOOLS 
- OE(D) M Service 
This Wifi Shield board is based on Serial to Wi-Fi module Wizfi210 from Wiznet and it is compatible with Arduino and its clones. The Wifi Shield offers you a quick, easy, and effective way to add Wi-Fi capabilities to Arduino. The Wifi Shield allows you to achieve Wifi communication via UART by sending AT commands, which is an ideal solution for whom with limited or no Wi-Fi or RF expertise. The Shield supports data rates up to 11 Mbps, and is compliant with 802.11b.
Serial(UART) to Wifi.
Simple AT commands for configuration and data communication.
DHCP/Static IP, TCP/UDP, Server/Client, DNS.
Operates with standard 802.11 b/g/n access points at speed up to 11 Mbps (802.11b).
802.11i Security (WEP, WPA, WPA2-PSK, Enterprise).
High-throughput hardware AES and RC4 encryption/decryption engines.
Limited AP Feature (Direct Connection to iPhone, iPad and Android-Phone without AP).
Ultra low power consumption through dynamic power management.
Wifi Chip: WizFi210
Radio Protocol: IEEE 802.11b/g/n Compatible
Supported Data Rates: 11, 5.5, 2, 1 Mbps (IEEE 802.11b)
Modulation: DSSS and CCK
RF Operating Frequency: 2.4 - 2.497 GHz
Antenna Options: Chip antenna and U.FL connector for external antenna
Networking Protocols: UDP, TCP/IP (IPv4), DHCP, ARP, DNS, HTTP/HTTPS Client and Server(*)
Power Consumption(Typical): Standby = 34.0 µA Receive = 125.0 mA Transmit = 135.0 mA
RF Output Power (Typical): 8dBm ± 1dBm
Security Protocols: WEP, WPA/WPA2-PSK, Enterprise, EAP-FAST, EAP-TLS, EAP-TTLS, PEAP
I/O Interface: UART, SPI(*), I2C(*), WAKE, ALARM, GPIOs
System Working Voltage: 3.3V
1 x Wifi Shield board
For more information please visit wiki page