Your Shopping Cart is empty.

  • StepStick A4988 Reprap Motor Driver with Voltage Regulators
    • i i
    • images/l/Geeetech_A4988VOT_1.jpg images/l/Geeetech_A4988VOT_1.jpg
    • images/l/Geeetech_A4988VOT_2.jpg images/l/Geeetech_A4988VOT_2.jpg
    • images/l/Geeetech_A4988VOT_3.jpg images/l/Geeetech_A4988VOT_3.jpg
    • images/l/Geeetech_A4988VOT_4.jpg images/l/Geeetech_A4988VOT_4.jpg
StepStick A4988 Reprap Motor Driver with Voltage Regulators


Shipping Weight:55g

Free Shipping!


Vote for specials.

0 votes


A4988 Stepper Motor Driver Carrier with Voltage Regulators using Arduino,PIC,ARM!Reprap printer
The A4988 stepper motor driver carrier with voltage regulators is a breakout board for Allegro’s A4988 microstepping bipolar stepper motor driver. The board has two voltage regulators (5 V and 3.3 V), eliminating the need for separate logic and motor supplies. The driver features adjustable current limiting, overcurrent and overtemperature protection, and five different microstep resolutions (down to 1/16-step). It operates from 8 – 35 V and can deliver up to approximately 1 A per phase without a heat sink or forced air flow (it is rated for 2 A per coil with sufficient additional cooling).

Simple step and direction control interface
Five different step resolutions: full-step, half-step, quarter-step, eighth-step, and sixteenth-step
Adjustable current control lets you set the maximum current output with a potentiometer, which lets you use voltages above your stepper motor’s rated voltage to achieve higher step rates
Intelligent chopping control that automatically selects the correct current decay mode (fast decay or slow decay)
Over-temperature thermal shutdown, under-voltage lockout, and crossover-current protection
Short-to-ground and shorted-load protection

Packing list:
1×14-pin breakaway 0.1" male header
1×8-pin breakaway 0.1" male header
1×A4988 Stepper Motor Driver Carrier with Voltage Regulators


For more information, please kindly visit Wiki Page.



login or register to add your words.