Your Shopping Cart is empty.

  • Stepper Motor EasyDriver Shield Drive Driver Board
    • i i
    • images/l/Geeetech_2014070830937_1.jpg images/l/Geeetech_2014070830937_1.jpg
    • images/l/Geeetech_2014070830937_2.jpg images/l/Geeetech_2014070830937_2.jpg
Stepper Motor EasyDriver Shield Drive Driver Board


Shipping Weight:65g

Quantity in stock:999937


Vote for specials.

0 votes


The EasyDriver is a simple to use stepper motor driver, compatible with anything that can output a digital 0 to 5V pulse (or 0 to 3.3V pulse if you solder SJ2 closed on the EasyDriver). It requires a 7V to 30V supply to power the motor and can power any voltage of stepper motor. It provides much more flexibility and control over your stepper motor, when compared to older versions. The microstep select (MS1 and MS2) pins of the A3967 are broken out allowing adjustments to the microstepping resolution.


•Compatible with 4, 6, and 8 wire stepper motors of any voltage

•Adjustable current control from 150mA/phase to 750mA/phase

•MS1 and MS2 pins broken out to change microstepping resolution to full, half, quarter and eighth steps (defaults to eighth)

•Power supply range from 7V to 30V. The higher the voltage, the higher the torque at high speeds

Note: Do not connect or disconnect a motor while the driver is energized. This will cause permanent damage to the A3967 IC.

Note: This product is a collaboration with Brian Schmalz. A portion of each sales goes back to them for product support and continued development.




EasyDriver Website


Example Arduino Tutorial in Portuguese

login or register to add your words.