- 3D PRINTER 
- Mother board 
- 3d printer components 
- 3D printer filament 
- Arduino &electronics 
- UAV 
- FRIENDLY ARM 
- DISPLAY 
- WIRELESS 
- ACCESSORY 
- COMPONENT 
- Household&tools 
This all-metal J-Head Hot End has faster controlled motion, less shaking of your machine, less energy use and importantly: faster printing! Normally the mechanism that drives the filament into the hot end (where it melts) is directly on top of the extruder. This creates problems of balance and oscillations with faster motion which you can see in your printing results and hear and feel when your machine is shaking.
If the filament drive mechanism is placed on a non-moving part of the 3D printer, it can be pushed into a tube. PTFE (Teflon) is useful because it is slippery: it has little friction with the plastic.This limits wear and loss of energy. The tube's other end is connected to the extruder's hot-end.
All metal enables working with Polycarbonate up to 300 degrees Celsius and with future materials that require higher working temperatures beyond those supported by plastic extruders and hot end.
Tested with PLA, ABS, polycarbonate, nylon and PVA.
The inner diameter of the bowden feed mouth is 4mm to print with 1.75mm filament,and 6mm to print with 3mm filament.
This long-distance J-Head hot end allow it apart from extruder to printer.
Specification of PTFE tubing:
Outer diameter:4mm or 6mm
Inner diameter:2mm or 4mm
1 x All-metal long-distance J-Head Hot End with Cooling fan,Cartridge heater and PTFE tubing
For more information, please kindly visit our wiki page.