Easyprint ABS setting

Post Reply
capt1701a
Posts: 4
Joined: Fri May 10, 2019 1:01 am

Easyprint ABS setting

Post by capt1701a » Fri May 10, 2019 1:17 am

Hi,

I'm new to the world of 3D printing so please be nice to me.

Can any let me know the setting for EasyPrint 3D for an A20M to print ABS as every time I set the ABS temp, it defaults to PLA settings?
I have looked around the software changed the material settings but I get a message about this does not affect slicing?

Any help would be gratefully received

User avatar
Admin
Posts: 486
Joined: Wed Nov 30, 2011 9:49 am

Re: Easyprint ABS setting

Post by Admin » Thu May 16, 2019 11:28 am

Hi, you can save the settings

capt1701a
Posts: 4
Joined: Fri May 10, 2019 1:01 am

Re: Easyprint ABS setting

Post by capt1701a » Sat May 25, 2019 12:17 am

Hi,

I think I have worked it out on where to alter the temp settings. Just to verify I have accessed the settings icon, then I have changed the temperature for the first layer temperature, print and bed temperature then clicked Apply then Finish and pressed OK to "the argument has been set but not used in slicing" message, then closed and restarted the program. Is this correct?

Post Reply