printer sd card not detected in repetier firmware

Post Reply
lld
Posts: 1
Joined: Tue Apr 09, 2019 4:53 pm

printer sd card not detected in repetier firmware

Post by lld » Tue Apr 09, 2019 5:03 pm

Hello,
I'm having an issue with my firmware not recognizing the sd card in the geeetech i3 prusa printer slot. The manual mentions a checkbox in the printer settings - printer tab, but nothing is showing up.
"The next check boxes define, what the printer should do, when a print is finished and if a SD card is available. If no SD card is available, the corresponding tab will not be displayed." https://www.repetier.com/documentation/ ... iguration/
Please help :)

Thanks
Top
User avatar
_kaktus_
Site Admin
Posts: 1257
Joined: Fri Dec 15, 2017 10:06 pm
Location: PL
Contact:
Contact _kaktus_

Re: printer sd card not detected in repetier firmware

Post by _kaktus_ » Wed Apr 10, 2019 2:53 am

Hello.
:mrgreen:

It happened that SD card slots did not work properly.
If you can check if the card detection contact in the slot is working well.
;)
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Top
Post Reply

Return to “Control Board”

Who is online

Users browsing this forum: No registered users and 13 guests