![Evil or Very Mad :evil:](./images/smilies/icon_evil.gif)
I have all the wiring sorted and the 3D Touch works on all the G code commands for self-test, stop, up and down and have put the G29 in the right place, but it still will not Auto Level after following thing all the wiki's, instructions, videos. I have tried with 2 different 3D Touches but still, none of the carriages move. It will go through a whole print cycle and extrude filament in the same place but nothing is moving apart from the extruder motor, and the 3D Touch still does not go through it's up and down movements either.
I hope you understand. I get so many personal messages from other Geeetech forum users asking if I have managed to get it working. The answer is still NO!
Has anyone tried the i3 Pro B Firmware on the i3 Pro A? The firmware layout is all different.
So Come on GEEETECH!!! please get this sorted once and for all!!!