GT2560 V3 Extruder Motor Not Working After Driver Upgrade

Post Reply
z3r0
Posts: 1
Joined: Fri Feb 22, 2019 3:29 am

GT2560 V3 Extruder Motor Not Working After Driver Upgrade

Post by z3r0 » Fri Feb 22, 2019 3:36 am

Hello,
I was upgrading my A10M with some TMC 2208s and when I powered on the printer I noticed one of the extruder motors was completely dead. I swapped back the old stock driver in case the new one was damaged but had the same result. Swapped the cables on the motors to check that the motor itself wasn't damaged and indeed swapping the cables powers the extruder, so the motor should be fine. I noticed a LED turns on right in front of where E0's driver board when heating starts, is this a diagnostics led?

Thanks!

EDIT: Solved. Bumped up Vrefs to 0.820 and reseated driver boards.

User avatar
William
Site Admin
Posts: 4215
Joined: Tue Jun 07, 2016 9:38 am

Re: GT2560 V3 Extruder Motor Not Working After Driver Upgrade

Post by William » Fri Apr 26, 2019 5:28 pm

Hi, does the extruder temperature has reached the preset temperature?
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest