How to retrieve slicer (printing parameters) config from a hard-drive?

Post Reply
khondoke
Posts: 34
Joined: Sat Jan 16, 2016 6:07 pm

How to retrieve slicer (printing parameters) config from a hard-drive?

Post by khondoke » Fri May 04, 2018 7:56 am

Hello, the motherboard of my laptop is gone. However the hard-disk seems fine. I used this laptop for my printer for a long time and developed printing parameters /slicing parameters using Slic3r for my Geeetech M201 3D printer. Is there anyway that I can retrieve the config files of slic3r. I used Repetier-Host along with built-in slic3r for printing. I badly need those configurations. Can anybody advice me, please? Thanks in advance.

Post Reply

Who is online

Users browsing this forum: No registered users and 41 guests