Printing with PLA - your experience

Post Reply
Posts: 1
Joined: Wed May 17, 2017 11:10 pm

Printing with PLA - your experience

Post by Tiamet3D » Thu May 18, 2017 12:08 am

Hi, everyone!

We're currently undertaking a small survey (won't even take a minute to fill out) on printing with PLA and we need you to participate. We'd like to know what your experience with PLA is, whether you use it or not. This way, we'd like to be able to cater to your 3D printing needs. It'd be awesome if you could help us by filling out the survey on the following link: ... sp=sf_link
Thank you very much for your help!

Best regards,

Posts: 0
Joined: Wed Dec 20, 2017 9:07 pm

Re: Printing with PLA - your experience

Post by LadyQ » Wed Jan 03, 2018 5:01 am

Do not buy FoxSmart pla . is erratic in extrusion. take too much heat to start and takes too much time to set fine tuning .

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests