Neither the hotbed or extruder heat up
Neither the hotbed or extruder heat up
I have been using my Prusa 13 A pro, occasionally, for about one year, with no problems. Today, when I set up to print, both the hotbed and the extruder would not heat up. Any help will be greatly appreciated.
Re: Neither the hotbed or extruder heat up
You need first check whether the hot bed and extruder line connection is good, especially with the board connection.
If above of all is ok,please refer to the following link:
http://www.geeetech.com/forum/viewtopic ... 19&t=17039
If above of all is ok,please refer to the following link:
http://www.geeetech.com/forum/viewtopic ... 19&t=17039
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: Neither the hotbed or extruder heat up
Thanks William! It was a loose connection. Printing nicely, as I am writing this.