The last five month my Mecreator2 worked without any problem. Today I switched it on and on the display are shown two lines with blocks. The whole day I searched the net to get the printer run, but nothing helped - but I really have no idea about it.
After all I think the GT2650 Rev B board might be defect, but I do not find a shop, where it is sold.
I want my Mecreator2 back
Re: I want my Mecreator2 back
Hi,as to LCD issue,here is a related post you can refer to:http://www.geeetech.com/forum/viewtopic ... 23&t=17040
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: I want my Mecreator2 back
Many thanks for Your fast answer William. After trying around for several hours I don't think it is an LCD issue. Since two days I cannot connect the printer to Simplify3D and it worked fine before.
I thought to try to play new firmware on the printer and tried to connect the GT2560 Rev B to the Arduino IDE and get the message "unknown board". Some other Arduinos work fine mit my mac.
Is there any way for me to check if the GT2560 is okay?
I thought to try to play new firmware on the printer and tried to connect the GT2560 Rev B to the Arduino IDE and get the message "unknown board". Some other Arduinos work fine mit my mac.
Is there any way for me to check if the GT2560 is okay?
Re: I want my Mecreator2 back
Could you send some pictures which the control board is power on?
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: I want my Mecreator2 back
Here it is. One of my problems is that I don't find the GT2560 Rev B documented or sold anywhere. Thank You for Your answers.
Re: I want my Mecreator2 back
Does anyone know, if it is correkt, when this three LED are shining?
Re: I want my Mecreator2 back
The three LED lighting show the necessary power 12V,5V is fine so that the control board can work properly.
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!