Absolutely desperate

otibook
Posts: 46
Joined: Thu Jul 23, 2015 12:47 am
Location: Madrid, Spain

Re: Absolutely desperate

Post by otibook » Mon Jun 19, 2017 12:58 am

Hi William.

Could you please tell me if is someone in Spain who could help me with the printer. I´m still trying to calibrate the printer an trying to print things like the PSU case. It´s absolutely impossible print pieces bigger than 5 or 6 cm diameter. The printer loose head position and the pulleys start the "CRACKS" that you saw in the videos.

Please I need help.

User avatar
William
Site Admin
Posts: 4675
Joined: Tue Jun 07, 2016 9:38 am

Re: Absolutely desperate

Post by William » Mon Jun 19, 2017 9:01 am

Hi,after watching your last video again and again,I think it's the assembling problem.Have you checked the assembling of the motor's pulleys and checked if the belts are too loosen?
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

otibook
Posts: 46
Joined: Thu Jul 23, 2015 12:47 am
Location: Madrid, Spain

Re: Absolutely desperate

Post by otibook » Mon Jun 19, 2017 6:36 pm

Hi William.

I have checked many times the alignment of the motors and the pulleys. Mysteriously, the belts and pulleys cracks much more when the belt it´s tight. However I will check and try again. I´ll report you as soon as I have tried.

otibook
Posts: 46
Joined: Thu Jul 23, 2015 12:47 am
Location: Madrid, Spain

Re: Absolutely desperate

Post by otibook » Fri Jun 30, 2017 5:54 pm

Hi William.

I have unmount an mount again the whole printer checking all alignments measures etc. I have been extremely careful in mounting. The printer seems to work a little smooth but the "cracks" are still there. May be I have won about 1 cm in diameter, being able to print pieces of 8 cm long in X or Y axis.

Thank you for your help.

User avatar
William
Site Admin
Posts: 4675
Joined: Tue Jun 07, 2016 9:38 am

Re: Absolutely desperate

Post by William » Sat Jul 01, 2017 11:46 am

You are welcome.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests