Hi Everyone,
I am new to Rostock 301, built one recently and works with home button connected with laptop. However when I started to test on heatbed, the LCD went blank and the heatbed was not heated up, this was the same when I tried to heat up the extruder as well. Could anyone please help to give me some advice where should I look into?
Rostock 301 heatbed/extruder not heat up
Re: Rostock 301 heatbed/extruder not heat up
Hi,
Check the temp for extruder and heatbed on LCD when your power your printer on,and they won't heat up unless the temp for them is "room temperature/0".
Maybe you can attach a picture of that.
And if you didn't get the temp above,then it may be some mounting errors on the thermistors of them.
Check the temp for extruder and heatbed on LCD when your power your printer on,and they won't heat up unless the temp for them is "room temperature/0".
Maybe you can attach a picture of that.
And if you didn't get the temp above,then it may be some mounting errors on the thermistors of them.
Re: Rostock 301 heatbed/extruder not heat up
Hi Bang,
Thx for letting me know. I will check that later and place some pictures if it is still not working.
Thx for letting me know. I will check that later and place some pictures if it is still not working.