Hey, I've recently bought a full graphic smart display that says "for ramps 1.4".
I was told by a friend that it would work with the Sanguinolulo board that the aluminum prusa comes with, but the connector between the board and the lcd cables are very different from ramps to my board.
Do I just use my own connector that the lcd2004 came with or is this not compatible?
The red one is the one that came with the new lcd and the white one is the old one.
http://imgur.com/zUZkdnk
http://imgur.com/f5y3sqb
http://imgur.com/V5FgYW5
http://imgur.com/osKPdfF
This is the lcd.
http://3d-grottan.se/Electronics/Electr ... ic-Display
Switching from LCD2004 to 12864 LCD
Re: Switching from LCD2004 to 12864 LCD
http://www.geeetech.com/3d-printer-smar ... p-703.html
this is the adapter of LCD for Sanguinolulo board
this is the adapter of LCD for Sanguinolulo board
Re: Switching from LCD2004 to 12864 LCD
That looks just like the adapter that I've got right now, is that adapter with this display compatible with the board that im using?admin wrote:http://www.geeetech.com/3d-printer-smar ... p-703.html
this is the adapter of LCD for Sanguinolulo board
Or am i gonna end up with a blank screen after trying.
I know that i have to change the firmware confirugration and set it to the "rep rap discount smart controller.." but the real question is, will this work?
Re: Switching from LCD2004 to 12864 LCD
if it is the same, i think it is compatible.