Mosfet problem

zhangxueyou
Posts: 1405
Joined: Fri Feb 06, 2015 1:33 pm

Re: Mosfet problem

Post by zhangxueyou » Mon Jun 22, 2015 9:02 am

It looks terrible, please contact the customer service.

Pgioy
Posts: 18
Joined: Wed Jun 03, 2015 12:51 pm

Re: Mosfet problem

Post by Pgioy » Sun Jul 05, 2015 3:12 pm

hello sorry if I send the message to you, but it's more than two weeks since I sent the e-mail where I have indicated, but even today I have not received any reply, you can help you. also because with the printer are stopped. thanks a lot

johnz
Posts: 23
Joined: Mon May 18, 2015 12:37 pm

Re: Mosfet problem

Post by johnz » Thu Dec 10, 2015 2:32 pm

My just did the same thing...did you ever find out what was wrong???!!

Mark
Posts: 1553
Joined: Thu Aug 06, 2015 9:19 am

Re: Mosfet problem

Post by Mark » Thu Dec 10, 2015 3:58 pm

hello, what's the problem with your board? see what I can do.

johnz
Posts: 23
Joined: Mon May 18, 2015 12:37 pm

Re: Mosfet problem

Post by johnz » Fri Dec 11, 2015 6:44 am

The Heat bed stopped working and then I looked at the board and this is what it looks like and the heat bed reading in pic 2.
Attachments
1000.jpg
1000.jpg (324.37 KiB) Viewed 9240 times
10002.jpg
10002.jpg (367.73 KiB) Viewed 9240 times

Mark
Posts: 1553
Joined: Thu Aug 06, 2015 9:19 am

Re: Mosfet problem

Post by Mark » Fri Dec 11, 2015 11:20 am

seems your hotbed resistance is ok, how about check this link here:
http://www.geeetech.com/forum/viewtopic ... 13&t=17117

johnz
Posts: 23
Joined: Mon May 18, 2015 12:37 pm

Re: Mosfet problem

Post by johnz » Fri Dec 11, 2015 12:37 pm

No the MOSFET is fried...Not working...check everything ...everything works except the hot bed!!! Just bought this in May 13, 2015 ....Cant believe it just fried like that,,,Damn!!

Mark
Posts: 1553
Joined: Thu Aug 06, 2015 9:19 am

Re: Mosfet problem

Post by Mark » Fri Dec 11, 2015 2:15 pm

then you can replace the mosfet yourself or contact the sales directly to replace it.

Post Reply