Substitute gt2560 with mega 2560 ramps 1.4

Post Reply
mava70
Posts: 20
Joined: Sun Nov 01, 2015 8:20 am

Substitute gt2560 with mega 2560 ramps 1.4

Post by mava70 » Wed Nov 04, 2015 3:45 am

Hello i have a prusa i3 b with gt2560 broken I would like to know if I can buy a standard mega 2560 + ramps 1.4 flash prusa b 2560 firmware and swap cables : it work witout software/hardware modification? I don't like that much this gt2560 too many problems.

Sherry
Posts: 362
Joined: Wed Jul 01, 2015 12:52 pm

Re: Substitute gt2560 with mega 2560 ramps 1.4

Post by Sherry » Wed Nov 04, 2015 8:56 am

i'm afraid that you need to buy cables for ramps1.4+maga 2560 because some of GT2560 cable do not fit to ramps 1.4.you also need a lcd adapter.
As for firmware,just burn the firmware for ramps 1.4
http://www.geeetech.com/forum/viewtopic ... 10&t=17046

mava70
Posts: 20
Joined: Sun Nov 01, 2015 8:20 am

Re: Substitute gt2560 with mega 2560 ramps 1.4

Post by mava70 » Wed Nov 04, 2015 4:34 pm

Hi Eric,

thank you, by watching picture it seems only power cable and fan cable is different. isn't it? Are Termistors compatibile?

Marco

mava70
Posts: 20
Joined: Sun Nov 01, 2015 8:20 am

Re: Substitute gt2560 with mega 2560 ramps 1.4

Post by mava70 » Wed Nov 04, 2015 4:36 pm

Thank I am not really expert to arduino hardware I was thinked that is it possible to find some ICSP pin around the board, but probabily is not the case

Sherry
Posts: 362
Joined: Wed Jul 01, 2015 12:52 pm

Re: Substitute gt2560 with mega 2560 ramps 1.4

Post by Sherry » Wed Nov 04, 2015 5:31 pm

mava70 wrote:Hi Eric,

thank you, by watching picture it seems only power cable and fan cable is different. isn't it? Are Termistors compatibile?

Marco
the thermistors are compatible.just some of cable maybe be not have a good contact with slots on ramps 1.4.

mava70
Posts: 20
Joined: Sun Nov 01, 2015 8:20 am

Re: Substitute gt2560 with mega 2560 ramps 1.4

Post by mava70 » Mon Nov 09, 2015 9:49 pm

Done,

thank you, I am printing now.

thanks

Post Reply