USB driver issues

Post Reply
Mark
Posts: 1553
Joined: Thu Aug 06, 2015 9:19 am

USB driver issues

Post by Mark » Fri Oct 09, 2015 8:45 pm

USB driver issues...I'd say sometimes it's the most hard one :(
The first thing, you should install the USB driver! And you'll find the COM port in your computer's device manager.

1. Cannot upload the firmware to the board
Sometimes the firmware is compiled successfully but just can’t upload it to the board, in this case you can unplugged all the other parts on the board and try to upload it again.

2. The driver is not well installed
If your COM port show the same information as the picture shows, it seems the driver is not well installed.
1.jpg
1.jpg (38.73 KiB) Viewed 6943 times
Try to reinstall it like this, and remember to select the correct COM port and motherboard in your arduino.
step01:
2.jpg
2.jpg (73.65 KiB) Viewed 6943 times
step02:
3.jpg
3.jpg (51.81 KiB) Viewed 6943 times
step03:
4.jpg
4.jpg (57.66 KiB) Viewed 6943 times

step04:
5.jpg
5.jpg (34.89 KiB) Viewed 6943 times
After this you can try to connect to your PC again see if it works.

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests