Once before printing is performed auto level, starts printing and the extruder begins to rise at 2mm from the table where the Z-axis, and a bit near the y-axis. What should I do ? I tired to configure YOUR PRINTER DELTA ROSTOK G2S
![Crying or Very Sad :cry:](./images/smilies/icon_cry.gif)
hi,you need to addjust corresapnding endstop screw.for examle,G0 X0 Y50 Z2 ,if nozzle tip do not touch bed surface even if you down z 2mm,you need to tighten up the corresponding endstop screw.if it touch the hot bed in advance ,you need to loosen the endstop screw.RusKZ wrote:Good. Tell me then how to configure it . extruder to move parallel to the table ?
when X 0 Y0 Z0 -good . when X- 50 Y- 50 Z0- well . at X50 Y- 50 Z0- good. but as soon as X0 Y50 Z0 - bad extruder rises to 3 mm from the table.