Feeder is Not pushing the filament
Hi guys. I have a little problem with my 3d printer. When i‘m loading or unloading new fillament the printer pushes it fine through the tube. But when i start a print the filament doesn‘t move anymore. The Motor with the gear is rotating but the feeder wheel is standing still. Any suggestions? Ps the Printer is a Geeetech A30Tweakbox Appvalley https://vlc.onl
Geeetech a30 Not extruding filament
-
- Posts: 4
- Joined: Fri Jun 18, 2021 1:11 pm
Geeetech a30 Not extruding filament
Last edited by LavenderBirch on Wed Jul 07, 2021 6:25 pm, edited 1 time in total.
Re: Geeetech a30 Not extruding filament
Hello, it may be that the feeding kit is too loose. You can adjust the pressure of the lower spring so that it can engage the filament exactly.
Re: Geeetech a30 Not extruding filament
Nope, same filament, same Cura settings, same ambient conditions and the filament WILL NOT adhere to the bed now! It just curls around the extruder nozzle.
Myloweslife
Myloweslife
Re: Geeetech a30 Not extruding filament
Hello, maybe the hot bed is not leveled correctly?
You can slow down or change the printing area to see if the consumables stick to the hot bed.
You can slow down or change the printing area to see if the consumables stick to the hot bed.