About how to connect the 3d touch

User avatar
William
Site Admin
Posts: 6330
Joined: Tue Jun 07, 2016 9:38 am

Re: About how to connect the 3d touch

Post by William » Sat Dec 21, 2019 11:52 am

:D Hi, The specific insertion method is 3pin brown wire on, 2pin black wire on.
you can refer to this:
3d touch接线参考.png
3d touch接线参考.png (140.09 KiB) Viewed 5193 times
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

lmcmulle
Posts: 32
Joined: Sat Nov 30, 2019 10:54 pm

Re: About how to connect the 3d touch

Post by lmcmulle » Sat Jan 18, 2020 3:58 am

orange on top and black on top is the working config

duglas
Posts: 3
Joined: Mon Feb 24, 2020 2:03 am

Re: About how to connect the 3d touch

Post by duglas » Mon Feb 24, 2020 6:03 am

So, i can't make it work following all your discussion. could you please write down a step by step procedure on where connect the wires, with a picture (that will be one among all the others) and links on the procedures to update-setup the program of the 3d printer and make it work (calibration).

thanks
Geeetech A20T 3 mix 1

Chany
Posts: 1
Joined: Wed Mar 11, 2020 8:08 am

Re: About how to connect the 3d touch

Post by Chany » Wed Mar 11, 2020 8:10 am

Bonjour,

Je viens d'acheter donc cette fameuse Geeetech A20T avec le 3D touch.
Ou se trouve le firmware avec le 3D touch pour cette imprimante. Je ne le trouve pas....


Merci

User avatar
William
Site Admin
Posts: 6330
Joined: Tue Jun 07, 2016 9:38 am

Re: About how to connect the 3d touch

Post by William » Thu Mar 12, 2020 10:09 am

Hi, the firmware with 3d touch is still being tested.
It will be uploaded after the test.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Fredoooo
Posts: 1
Joined: Thu Mar 19, 2020 5:17 pm

Re: About how to connect the 3d touch

Post by Fredoooo » Thu Mar 19, 2020 5:19 pm

Des news concernant le firmware 3d Touch pour la A20T??

User avatar
William
Site Admin
Posts: 6330
Joined: Tue Jun 07, 2016 9:38 am

Re: About how to connect the 3d touch

Post by William » Thu Mar 19, 2020 5:37 pm

Fredoooo wrote:
Thu Mar 19, 2020 5:19 pm
Des news concernant le firmware 3d Touch pour la A20T??
:D Hi,you can select the corresponding model to download on the download page of the official website.
You can refer to:viewtopic.php?f=20&t=70221
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply

Who is online

Users browsing this forum: No registered users and 25 guests