A10T profile

Sardauker
Posts: 10
Joined: Thu Jul 11, 2019 11:24 pm

Re: A10T profile

Post by Sardauker » Mon Dec 16, 2019 2:29 am

Wipe and prime volume.

Try increasing that, you'll See the tower Will grow in area.
(If I Remember my math, doubling the volume wil increase the side of the tower of *1.41)

Now, if i Just could understand how to pur that tower outside the plate...

ThomasGee
Posts: 17
Joined: Mon Oct 14, 2019 8:56 pm

Re: A10T profile

Post by ThomasGee » Mon Dec 16, 2019 3:20 pm

Nope,
no change of size

ThomasGee
Posts: 17
Joined: Mon Oct 14, 2019 8:56 pm

Re: A10T profile

Post by ThomasGee » Mon Dec 16, 2019 3:38 pm

at least, if there is change, it is not big enough.
The nozzle hits the tower and moves the bed in the wrong direction.
The more colorchanges in the print, the more the nozzles moves the bed. There aer then 3 colors on one layer in the tower.

Sardauker
Posts: 10
Joined: Thu Jul 11, 2019 11:24 pm

Re: A10T profile

Post by Sardauker » Mon Dec 16, 2019 6:38 pm

Same here, no matter the side of the tower.

This Is why I am looking for the purge bucket option.

Sardauker
Posts: 10
Joined: Thu Jul 11, 2019 11:24 pm

Re: A10T profile

Post by Sardauker » Sat Jan 04, 2020 7:22 pm

is there AT LEAST a way to put the purge tower outside the bed?

Jarda3d
Posts: 189
Joined: Sat Jan 26, 2019 8:42 am

Re: A10T profile

Post by Jarda3d » Sat Jan 04, 2020 10:20 pm

A10M Slic3r profile: here and fresh on github (lot of tips here)
A10 Slic3r profile: here
TIP: tight all screws and wheels (except right side of Z axis) and re-align frame while assembly. And silence it.

Post Reply