Power supply tripping

compton
Posts: 6
Joined: Fri Aug 02, 2019 4:19 am

Re: Power supply tripping

Post by compton » Tue Dec 17, 2019 6:10 pm

For anyone else having this problem, eventually I traced it back to one of the PSU mounting screws being a little too long and pushing onto the circuit board inside therefore shorting out the outer metal case.

User avatar
_kaktus_
Site Admin
Posts: 1258
Joined: Fri Dec 15, 2017 10:06 pm
Location: PL
Contact:

Re: Power supply tripping

Post by _kaktus_ » Wed Dec 18, 2019 4:24 pm

Hi.
:mrgreen:

Bravo for perceptiveness ... That's a very important point. :!:
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests