I have a problem with the extruder.

Post Reply
Dommovoy
Posts: 2
Joined: Thu Aug 01, 2019 6:29 am

I have a problem with the extruder.

Post by Dommovoy » Thu Aug 22, 2019 5:38 pm

http://prntscr.com/ow02hr
http://prntscr.com/ow02ns

1. I reset to factory settings
2. I have adjusted the bar clamp
3. I changed the firmware
4. I changed the feed rate of the bar and added / removed rollback
everything is completely cleaned.

I ask you in detail, with pictures, for points to help in solving this problem

Sorry for my english

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: I have a problem

Post by William » Thu Aug 22, 2019 5:52 pm

Hi, It seems that the distance between your two gears is too close,
you can try to adjust the distance properly;
then adjust your printing speed (reference range 30-60mm / s).
I hope this can help you.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Dommovoy
Posts: 2
Joined: Thu Aug 01, 2019 6:29 am

Re: I have a problem

Post by Dommovoy » Thu Aug 22, 2019 11:23 pm

I adjusted these settings, both physically and programmatically, did not help

User avatar
_kaktus_
Site Admin
Posts: 1260
Joined: Fri Dec 15, 2017 10:06 pm
Location: PL
Contact:

Re: I have a problem

Post by _kaktus_ » Mon Oct 14, 2019 7:18 pm

Hello.
:mrgreen:

This happens when the filament does not find an outlet, or is fed too quickly.

So it's worth it:
  1. Level the heated bed,
  2. Adjust the gap between the nozzle and the heated bed surface,
  3. Adjust the temperature of the hot end,
  4. Check that the Teflon Bowden tubes are properly cut and sufficiently deep seated,
  5. Clean the entire hotend, it must not be clogged in whole or in part,
  6. When the filament is of poor quality, similar problems can happen,
  7. Perform extruder calibration.
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.

Post Reply