Heating failed & Dual Extrusion not working

Post Reply
krmmr
Posts: 3
Joined: Thu Jul 18, 2019 5:23 pm

Heating failed & Dual Extrusion not working

Post by krmmr » Wed Aug 21, 2019 8:21 pm

Now after i tightened the knob at the extruders and set my e-stops/mm to a higher value i get "fine" extrusions..

BUT

After some time the printer stops saying Heating failed. I tried printing the dice two times, one time it put out this message on the 2nd or 3rd layer the second time it stopt at the 10th or something like that.
I used CURA 4.2.1 to slice it. My A20M is only one month old and i did not get any good prints with it yet.. except the dog..
WhatsApp Image 2019-08-21 at 14.12.47 (1).jpeg
WhatsApp Image 2019-08-21 at 14.12.47 (1).jpeg (141.69 KiB) Viewed 3326 times


My other Problem is that the first layer is correct (white outside and gray dots for the dice) but every layer after the first is inverted? I dont know why.. Used a large Primetower which definitely wipes all old material..
WhatsApp Image 2019-08-21 at 14.12.47.jpeg
WhatsApp Image 2019-08-21 at 14.12.47.jpeg (206.8 KiB) Viewed 3326 times
WhatsApp Image 2019-08-21 at 14.12.47 (2).jpeg
WhatsApp Image 2019-08-21 at 14.12.47 (2).jpeg (207.87 KiB) Viewed 3326 times

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Heating failed & Dual Extrusion not working

Post by William » Thu Aug 22, 2019 9:11 am

Hi, You can check if the thermistor wiring of your hot end and hotbed is fully connected.
Then measure the thermistor.

You can try to re-slice the model.
From your print model,
You may need to 1.adjust the printing speed and reduce it appropriately. The reference range is 30-60mm/s.
                     2. Check the tightness of the belt;
                     3. Check if the bearing and the pulley are issued (the card can be lubricated for lubrication).
I hope this can help you.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply