Geeetech A10 bltouch issues?

Post Reply
avicci
Posts: 1
Joined: Fri May 13, 2022 10:41 pm

Geeetech A10 bltouch issues?

Post by avicci » Fri May 13, 2022 10:42 pm

Recently upgraded to BL touch on my A10 printer. Flashed the appropriate firmware from their website. However when I go to run the bed leveling sequence it finds center but then when it goes to probe the front left corner the probe is off the table and I get a prob fail error. It appears it doesn't know the BL touch is offset from the nozzle and I don't see anyplace in the firmware to set it? Any way to set a X / Y offset if not in firmware? The Z offset is there and adjustable.

Post Reply